Organic Cannabis - Circular Ashtray

pinshape

Hello there, Its quite fun to print this one as you can mix a bunch of different colors when printing it.  For printing parameteres I've used the following, Material: PLA Layer height: 0,25mm Walls: 3  Top/Bottom: 4 Speed: 40mm/s Nozzle = 207°C Bed = 75°C (quite cold here) No supports *** Prints in about 5h and uses approximately 43g of filament. Following these parameters, you should need to pause the print at these intervals (set up timers): 18' - From blue to green 1h02' - From green to red 1h16' - From red to white  1h30' - From white to red 1h48' - From red to blue  *** As PLA melts with heat, before using it as an ashtray, make sure to apply some kind of epoxy on top of the base drawing.