Orchid Vase

thingiverse

This is a vase I crafted for my orchid which had been neglected far too long. I conceived the idea of designing the vase to resemble leaves at the base of a flower. For an orchid, you don't want it to hold any water. You prefer to water it just once a week or so and let all the water drain out, so this vase isn't waterproof. I submerged it in the sink and filled it with water, then simply left it for about an hour to drain before placing it back on the table. I printed it in white ABS plastic. Note that the bottom isn't perfectly flat, so you may want to adjust it slightly below the build surface in your slicer program to ensure the base is level.