Orbit Sprinkler L connector repair part

prusaprinters

This Orbit sprinkler has a heart-shaped cam driven by (I presume) an impeller inside the sprinkler body. the cam drives an L shaped connector with two studs on the ends. The connector then saves the bar back and forth, which controls the direction of the spraying water. https://www.instagram.com/p/BX3siccn5Vz/?taken-by=imakerobots My sister gave me the sprinkler when one of the studs had worn off. I took a few tries to get the tollerances just right, but I got it. Interesting to note that the original piece could have had much tougher studs but the designers chose not to. Design for failure? https://www.instagram.com/p/BX4TNIJg2AT/?taken-by=imakerobots Support me through Patreon: https://www.patreon.com/imakerobots Or make a one time donation: https://www.paypal.me/imakerobots Every like, share, and subscribe helps! Blog: http://marginallyclever.com/ Instagram: https://www.instagram.com/imakerobots Facebook: https://www.facebook.com/MarginallyClever Twitter: https://twitter.com/aggrav8d Discord: https://discord.gg/Q5TZFmB Print Settings Printer Brand: Prusa Printer: i3 MK2S Rafts: No Supports: No Resolution: 200um Infill: 20% Notes: I flipped the model over before printing. How I Designed This Fusion360 I also made sure to print out a 1:1 drawing and compare it to the original part to check that my caliper measurements were OK. Still took three prints to get it right! Those are some tight tolerances. Category: Outdoor & Garden