Orballo p3steel Ramps 1.4 enclosure

thingiverse

Hi, I've modified this box to fit a Ramps 1.4 board onto the Orballo frame (not sure on the version I have but it's been around for a couple of years). The door is designed to use a 50mm fan and has been set up to mount on the outside, due to lack of space inside; however, if space permits, it can be mounted inside. At present, the case sits flush with the frame, but I might add a spacer to improve airflow through the rear. The link to the magnets I used is below; you may have to reenlarge the hole a little - I fixed them using superglue: https://www.amazon.co.uk/gp/product/B00ZNUTGVG/ref=ppx_yo_dt_b_asin_title_o01_s00?ie=UTF8&psc=1 Issues that I can live with, but you may want to adjust: Issue 1 - As the Ramps board is deeper than most boards, I've had to make the case thicker. This means it doesn't open fully, but since I don't go in here very often, it's not a problem for me; however, you could add in a cut to allow it to open further. Issue 2 The bottom frame mounting holes do not align correctly, but I found that two bolts were more than secure.