Orb Audio two speaker horizontal mount (Mod2)

prusaprinters

I created this bar to reduce the (visual) clutter on my workstation by mounting two sets of two orbs (four total) horizontally. They sit on my desk under my monitor.Vitamins:2 orbs2 screws from original Orb stand1 original Orb stand (e.g. from Mod1)Printing:Find the slot where the original Orb stand is inserted. Print with this slot facing up - the opposite side should be on the build plate (see photo)If your cooling is sufficient, or you don't care about perfect circles where the bolts are inserted, print without supportsAssembly:Remove all stands from your OrbsNot the orientation of the slot in the middle of the part - this is where the stand will be inserted, so you want it facing downInsert two screws into the back of the partAttach two Orbs using the screws - route the wires however you'd likeInsert the original Orb audio stand into the slot on the bottom sideEat Haribos