Orange Lantern Ring - No Supports

thingiverse

I tried to simplify APUC's design, removing the supports that people use to attach their own custom parts. However, when I used APUC's settings in Simplify3D, the print wasn't very clean due to the difficulty in getting it to slice well and then fusing it with the ring. After measuring the ring, I believe it's a standard US size 14. Here are my print settings: I'm using my Robo 3D R1 printer model. My printer is set up to print ABS and PLA plastics. When I'm printing, I usually have rafts enabled and supports too. The resolution is quite high at .15. For infill, I always use 30% or more, as this helps build the model's strength. I know it might not be necessary, but for better adhesion with the print bed, I often enable a raft. Also, because the APUC model is delicate, it requires good support settings in order to turn out well. Any setting above .2 mm will probably lead to some unsightly imperfections on the finished piece.