Oral-B Toothbrush Holder

thingiverse

I designed this Oral-B toothbrush holder after my wife wanted to buy one on Etsy. This holder is a completely original design, but there are a few holders on Thingiverse that I used for initial guidance. All of the toothbrushes I have are different Oral-B models, but they all fit in the same way, including the small rubber nub in the back to keep it from rolling. The bottom of each slot is tapered down towards a center hole that allows for drainage. The toothpaste slot is for a Colgate tube, but it could most likely fit other brands. No special print settings, but I did use PETG so provide a little more strength and flexibility. It was mounted using JB Weld 2-part epoxy putty, so it is water proof, strong enough to handle lots of use, and gives a cleaner look than with screws. My plan is to eventually add a clip-on to allow a charger to be attached. You can adjust this print to best fit your needs. Please do not post iterations without contribution. Thanks!