Oral-B Braun Genius 9600 Toothbrush Charger Wall Mount

thingiverse

UPDATE: This first design printed really well however the tolerance on the dovetail section of the mount was too tight and the round part of the charger did not go in. In V2 i have increased the tolerance on the dovetail and widened the rounded portion of the charger base holder as well as added more sides for a smoother more "circular" slot for the charger to sit into. The second design (V2) fits perfectly and the charger holder slots very easily on and off of the mounting block for cleaning! This is a wall mount for an Oral-B Braun Genius 9600 Electric Toothbrush charger. It will work with any Oral-B Braun toothbrushes that use a type 3757 charger. It may fit other chargers/brands too but i don't have any way to test that. This gets it off your counter and frees up counterspace! There is a slot to run the cord down and through that is big enough to fit the whole wall plug through. The wall mount portion stays on the wall and the charger holder portion can come off so that you can clean the holder and toothbrush charger whenever needed! It is 2 parts in 1 file and should print without supports however you may want to use supports for the part where the cord goes through. I will update once i have printed it. The wall mount portion has 2 holes that should fit most standard wall anchor screw with a head of 9mm or smaller. The screw holes are counter sunk so that the head of the screw does not interfere with the slots to attach the charger holder.