OpenRC F1 Reinforced Nose with embedded M3 Nuts

thingiverse

I'm experiencing difficulties inserting m3 nuts into the original nose, so I've redesigned it with embedded m3 nuts for easier assembly. Another challenge with the original design was that hard crashes often caused the nose to snap in two along the layer line. To mitigate this issue, I've revised the part to be printed with a 105° rotation and the bottom facing down, which significantly reduces the likelihood of snapping in half and makes it more resistant to impacts. However, after adding a reinforced front wing, I found that the nose still required additional strength to withstand more severe crashes, so I've created an enhanced version with strengthened areas that were prone to breaking.