Openlock Magnet Clip Create Tool

cults3d

These two tools help create magnetic clips for openlock. The drill case holds up to 10 clips, which are secured in place with the drill bar. You then drill the clips and, once done, use the drill pusher to eject the prepared clips. The Clip Tool Holder requires three-by-three magnets to be placed within it, positioned in opposite pole orientation - one magnet north-south and the other south-north. Small holes at the bottom allow you to push them out if necessary. Next, when finished, place two additional magnets on top of these (which will eventually be inserted into the openlock mag clip). In the Clip Tool Pusher, position the magnetic clip and then slide everything into the clip tool Holder. Finally, push the magnets into the clip and pull it out. If the magnets are not fully seated, insert the pusher into the holes on the back of the holder to facilitate their insertion. Please comment if you encounter any difficulties in understanding these instructions!