OpenLock Floor Supports

thingiverse

These are a set of floor supports designed specifically for OpenLock primary floor tiles, allowing them to be stacked if necessary to combine them when required. Currently, these supports cater to OpenLock floor tile sizes E, R, S, and U. Each support comes in four different heights: 1-inch, 2-inch, 18mm, and 37mm. The purposes of these heights are as follows: * A 1-inch height positions the underside of a tile at the top of a low wall. * A 2-inch height places the underside of a tile at the top of a full 2" wall. * An 18mm height lines up the top of the tile base with a low wall. * A 37mm height aligns the top of the tile base with a full 2" wall. The supports are compatible with OpenLock v7.6 bases. **Important Note:** The pegs on each support may obstruct one of the end Triplex connectors on each edge, but for most orthogonal connections between tiles, this should not be an issue. Original inspiration was taken from <https://www.thingiverse.com/thing:3020197>, but they were modified to work with OpenLock 7.6 and include full sides.