OpenGarage Enclosure V2

thingiverse

This is a remix of [a TinkerCAD design created by user rayshobbyshop](https://www.tinkercad.com/things/fSLeOxNVjwK-opengarage-enclosure). It's an enclosure for board version 1.4 of the garage door controller from [opengarage.io](https://opengarage.io/). Other controller versions may also fit, but results will vary. Features... * Specifically designed to fit the OpenGarage v1.4 board. * Built-in M3x10mm socket cap screws allow for flat mounting against a surface. * Enlarged back plate mounting holes accommodate #8 screws. * Additional case holes are included for the reset button and screw terminals. * A hole is provided for 90° header pins on GP4/GP5/GND for external door sensors. With header pins installed for an external door sensor, some additional adjustments may be necessary around the ultrasonic sensor holes to get the board into the case. If you print with translucent filament, it's possible to see the status LED on the ESP component. I've also made [the remixed design available on TinkerCAD](https://www.tinkercad.com/things/2qRHEHzTHSL) as well.