OpenForge 2.0 2x Wall Base

thingiverse

I prefer being able to attach walls anywhere along the edges when building dungeons, but I discovered that the available bases didn't meet my requirements quite perfectly. The initial problem I encountered was that my walls ended up tilting backwards due to the base being too narrow, causing the wall to collide with the adjacent floor piece. To resolve this issue, I expanded the base just a fraction wider than the widest part of the wall's lower section. I wanted my walls to be reversible, so I widened the channel for the magnet to allow it to roll towards the side it is attaching to. This modification provides a slightly better "stick" than centering it in the base alone. Additionally, I desired the OpenLOCK connector, but my FDM printer struggles with printing overhangs, so I opted for the "topless" version instead. By widening the base, the connector no longer clicked into place, prompting me to add small catches at the center of the bump to facilitate its use. Although this modification may mean they're not true OpenLOCK connectors, they should remain fully compatible with existing designs.