OpenBuilds power supply (PSU) panel mounts/standoffs

prusaprinters

<p>These are mounts/standoffs to mount the OpenBuilds power supply (PSU) on a panel. The distance between the PSU and the panel will be 15mm to allow airflow on all sides.</p> <p>To complete the build, you'll need 4 M3 thread inserts that can be inserted in the mounts with a hot (250 deg C) soldering iron.</p> <p>To use these mounts, you have to open the PSU and remove the 4 screws that hold the circuit board (PCB) down. You can then use 10mm M3 bolts to replace these screws. These bolts will exit the bottom of the PSU and can then be screwed in the mounts/standoffs.</p> <h3>Print instructions</h3><p>I printed this in PLA at 0.2mm layer hight without supports.</p>