OpenAstroTracker - Digital Level Holder

thingiverse

I wanted to add the Digital Level Addon to my OAT, but i did not like the position of the MPU6050 sensor in the official project STL-file (too far at the back, so longer cable runs etc). In this remix, I moved the MPU6050 sensor to the front and changed the cable duct to work nicely with the MKS + LCD case. Additionally, I removed some material at the back of the holder to save approx 20% of filament and added a lid.In order for everything to fit nicely, make sure to:Glue the sensor in place with a bit of superglue. I also did this for the wires on the front-facing edge of the holder.Use lens head screws on the lid of the MKS case (M3x8 worked fine for me).Attach the MKS case below the OAT using the provided MKS-case-spacer.STL using M4x30 screws. I put a M4 washer on each screw, put it through the case (bottom side), added the spacer and the T-nut (on the upper side of the case), and attached it to the extrusion.Note: I also use the GPS-Addon, but I just put heat-shrink tubing around the Neo6M module and threw it inside the MKS case. Until now I did not encounter any issues with this setup.