Open Sprinkler Base

thingiverse

This a case for the OpenSprinker TIAO board. The stands inside the case are 6 mm tall so you should be able to use a variety of screws to hold it in (I used 3mm). 2 holes to mount the case to a wall (internal for a clean look). As with all the cases I've designed, the top is held by friction, but it's not super tight. For that, I've included 2 internal 'Stands' both in the top and bottom. These take standard 8mm x 3mm hobby magnets. I glue them in (But you can compress them in too) and it just makes for a nice way to remove the case and put it back with out any hassle and gives a clean no screw look for the outside. The design on the top is recessed .25mm, giving the design a 1 layer indent. I printed with sliver for layer 1, then a filament swap to black for layers 2 and 3, then back to silver for the rest.