Open differential for 3Dsets Jeep Rancher

thingiverse

This is open differential for Jeep Rancher from 3dsets. I test it on version Wagon, but should be possible to mount it also on other versions. I created it this open diferencial, because I'm using my Rancher in house on vinyl floor and the adhesion is so good - and it overloads cardan joints. The idea was to use maximum of original parts. For two pieces of differential you need only: 6x bearings 10X15X4 6700 2RS (same like is used everywhere in Rancher) 10x screw M3x12 and 3d printed parts Print settings for case/box 0.2mm-20%, all other parts 0,15mm-100% infill I printed on Prusa Mini Assembly manual should be clear from photos. Don't forget put in grease. NOTE: Maybe it will be necessary to shorter Drive Shaft - Differential side, because new differential is little bit longer. On my Wagon version I did only for front axle.