Open Access Control Mounting Bracket

youmagine

Mounting bracket for Open Access Control System's 23b board version 2.11 (see http://code.google.com/p/open-access-control ). Adjust the size of the board and wire holes according to your laser's kerf. They're set at 0.1", which was suitable for #4-40 screws on my machine, but may be too loose for yours. The wall holes are set to 0.3" and 0.15" for drywall screws, so check your measurements. Any length screw can work, just factor in the space taken up by the Arduino beneath the OAC board. I recommend using 3/4" for the board and 1/4" for optional wire management holes. Eventually, this mounting bracket could be part of a complete laser cut enclosure.