Opel-Maultier Half Track 28mm

thingiverse

Important notice: I have received word that some individuals experienced difficulties printing the rear section of the radio truck. This issue arose from my previous cutting actions to separate the original one-piece file. I have rectified this problem by creating a new file titled "rear radio cab v. 2.0." The piece has been reinforced and the bottom of the cab has been smoothed out. I would like to extend my gratitude to Dominique for bringing this matter to my attention. This is a 28mm model of the Maultier half-track, a workhorse of the Wehrmacht during WW2. To create this model, I have taken two smaller scale one-piece models and scaled them up to 1/56th (28mm). These were then broken down into multiple printable parts. One-piece prints are not feasible in 28mm scale. For the basic transport Half Track, you will need to print the following files: 1) The two front wheels 2) Left and right tracks (these are not interchangeable; they fit snugly into recesses of the chassis) 3) The hull 4) The cargo cover if a covered bed is desired The radio truck/Command Post requires the following prints: 1) The two front wheels 2) Left and right tracks (these are not interchangeable; they fit snugly into recesses of the chassis) 3) The radio truck chassis 4) The rear radio cab 5) The roof-mounted antenna - print this piece without any brim or support, as it requires support for most other pieces 6) The locking nubs - these fit recesses in the radio truck chassis and the radio cab, ensuring proper alignment and a secure bond.