Onewheel Pint Front Rollers (Fangs)

thingiverse

Note: Thingiverse's 3D is broken. The area between the posts should be empty and that bar does not exist in the STL. A roller for the front of your Onewheel Pint. ***USE AT YOUR OWN RISK. NOSEDIVES MAY RESULT IN INJURY OR DEATH!*** This 3D model allows you to print out some simple and durable rollers. If you print this model, it is kind-of tall so it is better to put it on the leading edge of the board instead of the bottom. On the bottom it can run into the edge of small potholes and cause problems. (You may fall or drop your phone instead of falling, like I did. Haha! I have to print another one now because I broke this one off.) My suggestion would be to use 100% infill, and cover the print in a layer of epoxy resin. Bolts I used for the wheels are a standard 5mm wide bolt and nut. The box says, "Stove Bolts, red No. 2, 3/16 x 1-1/2" I used some generic skateboard bearings I found on Amazon. I have never tried doing a nose slide yet but I figured it would be good to print a roller in case I do an accidental nosedive. No sudden stops, please! I used 2 sided foam strips from the dollar store to adhere the roller to the board as well as bumper plates and various other parts and they have not come off.