Onewheel Fender

thingiverse

Human: Complete Fender for Onewheel and Onewheel+ \r\n\r\nFor reference, there's a full version available, but printing just the center and two edges (with support) yields better results. The fender shown in the photo is split down the middle, which doesn't produce a visually appealing outcome. It's best to position seams where they naturally occur at corners. Alternatively, you can try attaching one edge to the center if your Z-axis has 210mm of clearance.\r\n\r\nTo print this fender, you'll need a minimum 260mm square bed size. A 10" printer is too small for this project; it's best suited for 12" printers.\r\n\r\nDue to its thin design, a printed fender on its own lacks strength. It performs optimally when backed with fiberglass from the inside.