OneUp Carriage Holder

thingiverse

This is my very first upgrade on the OneUp - it solidly attaches the X-axis carriage to the belt. As far as I'm aware, it should work with TwoUp too. It's an enhancement of simple_x_carriage_v003 created by MarkQV. It won't stay on this printer for long because regular tape wasn't able to keep everything in place properly. The initial prints were fine when using black document clips for securing things but unfortunately, I lost way too much x-axis range due to them being stuck on. Installation Instructions I printed it with a layer height of .3mm and 20% honeycomb infill, even though I'm not really sure if the extra support was necessary. After printing, you just need to slide it in between the extruder assembly and the belt and then secure everything firmly. The design is small enough that no disassembly of the printer should be required for installation.