OnePlus One Foldable Stand

thingiverse

Simple foldable stand prints in one piece. Meant for landscape mode, but also works in portrait mode if placed near the bottom of phone. Pictured is Version 1 (OpoStand_WithSupport.stl). Recommend choosing file with added support and print slowly at fine detail settings. Version 2 has chamfers to minimize support structure but is a bit more challenging to print. Be careful not to scratch backside of your phone!!! I sanded the one in pictures thoroughly before attaching it to my OPO. UPDATE: As you can see in comments, Slic3r does not like V2 with support. Added new file that should be ok with Slic3r (at least it works with my v.1.1.7). Instructions After printing, cut the support carefully. The cylinder should snap free pretty easily and rotate if you give it a solid push first time. Clean up print and use sandpaper to get smooth, especially on the inside or it might scratch your precious OnePlus One. (Print slower if needed to get better finish). Layerheight 0.2mm. Infill 20%. If Slic3r crashes on V2_WithSupport please use alternate Slic3rOk version.