OnePlus 2 USB base

thingiverse

This is a remix from the awesome OnePlus Two Usb Dock (For One Plus Two) by nexster.http://www.thingiverse.com/thing:1103649\nI loved the design and decided to modify some features:\nTo fit my OnePlus two case.\nTo use another USB C cable to keep the red one for mobility free.\nSo I redesigned around a new connector, forcing it to stay in place when pushing down or pulling up the phone.\nThe USB C cable has a slight pinch under its curve to secure it.\nThe speaker cones are also slightly wider.\nThere are two retainers that allow landscape orientation.\nThe link to the usb c cable used is:http://amzn.to/2k6N26w\nIt fits perfectly with the oneplus 2 case.\nThe case used was:https://oneplus.net/ca_en/oneplus-2-translucent-gray-case\nYou can scale up the dock to fit larger cases, but the USB connector may loosen a bit.\nInstructions:\nPry the connector from the back then upward and completely remove it in the phone opening. Rotate it 90° and push it back down to its location until it is fully in place, pull the loose cable if necessary. Look under it and pull the loose cable from the back until it pinches between the two bumps in the curve (3.5mm wide for 3.9mm cable). The connector is then locked and will not move up or down when the phone is inserted.\nEnjoy!http://solidutopia.com\nPrint Settings:\nPrinter: Solid Utopia V1\nRafts: Doesn't Matter\nSupports: Yes\nResolution: 0.2\nInfill: 15%\nNotes: I used support to print it, but I think it would work fine without support anyway.