One Piece Rotational Motion Sculpture

cults3d

-Rotational Motion Sculpture- !WARNING! THIS SYSTEM WAS DESIGNED TO OPERATE ON A 220V NETWORK AND CANNOT BE DONE BY CHILDREN. WE ARE NOT RESPONSIBLE FOR ANY KIND OF PHYSICAL OR PROPERTY DAMAGE. The materials to make the swivel base in addition to the STL are: 1 - A 220V microwave motor 1 - Radial ball bearing - 6208z 1 - Seesaw type switch 1 - male type connector 1 - Insulating tape 3 - 47K 1W resistors 3 - Diode IN 4007 3 - Leds Chip 3w Cold White 6000-6500k 1 - tin solder 1 - Power cables with a diameter of 2.5mm (at least 1 meter in length) The system can be with or without the LEDs, if the maker wants without the LEDs, just connect the motor directly to a 220v network, in this case the use of diodes, resistors and LEDs is ruled out. Likewise, the use of the motor is also optional, if you don't want the base to move, just exclude the electrical gear from the set.