one hitter filter

thingiverse

I made an edit based on "slavikk"'s joint filter design, which can be found at https://www.thingiverse.com/thing:478759. The main goal of this project is to prevent any material you're smoking from entering your throat. For the best results, I recommend printing with PLA. As for supports, I didn't need to use any because of the design's simplicity. To achieve a strong and tight seal, I used an infill of 20 percent. I also printed with just one shell, which worked well for this particular design. Additionally, I wrapped 1 layer of E-tape around the end of the one hitter to ensure a secure fit. Please note that if you use a dugout, your one hitter may not fit inside it due to its size.