on-target bullseye door

thingiverse

Descriptionon-target bullseye door. This can be a one shot latched door when mounted hinge to the bottom or it can be an open swing entry and re-close door when the hinge is mounted upward.This on-target fixture was designed for the 6-Shot Disc Shooter by uhltimate but can be used with other things.There are pre-rendered supports in the clips. Cut them out. No beauty needed in the finish.The latch for the door is simply a pressure hole into the frame.See these in motion herePrintingThese are thin wall fixtures.Good layer adhesion requireddesigned for .4mm at 2mm layer.Frames print face downRemove the support material from the springsDoors print face up so you can customize themCUTTING the boxCutting holes could be dangerous. Use caution to avoid personal injury. Certain power tools may be facilitate cutting.For this one you will need the template. You should be able to cut on the lines.Any pressure on the frame from a deformed hole could prevent the latch from engaging.The box:3-7mm thick is good.Less than 3mm you may need to place the templates in the back to make the space behind the clips closer.AssemblyThe reset lever slides through the front, put the door on and slip the pin through.Place the doorInsert the pinOther models:on-target flip and swingson-target funnel targetson-target spinner targeton-target disc shooter hoop trackDon't Forget Night ModePut a flashlight in the box and enjoy illuminated targets.