OMP M2 2020/Explorer Version UC Mounts

thingiverse

Hey All. Right on the heels of my initial OMP M2 UC mount (https://www.thingiverse.com/thing:4169853) designed for using deeper LiPo's, I've got a new Explorer version in hand and have created the same mod. The idea remains the same as before - dropping the front crossbar by 3mm to accommodate taller LiPo's when utilizing the tray. You can implement this without altering the rear setup at all; the only change is that the tail won't sit level and will be racked upwards slightly to lift the tail rotor further away from the ground. I do, however, have a rear Jumper R1F receiver and rear UC mount available, which adds an extra 1mm of height to the rear. Please check out my other designs. After printing, it's recommended to run a 1mm diameter drill through the holes to clean them up, and all stock screws are still used. Ian Contessa