OmniStand Compatible Quick Connect Filament Spool Stands

thingiverse

Omnistand Compatible Quick Connect Filament Spool Stands PRINTER COMPATIBILITY The OmniStand quick connect stands are compatible with a wide range of printers including FlashForge Dreamer and Dremel 3D Idea Builder. These stands can be used with various filament spools from popular brands such as ASAPTech, ColorFabb, Dremel, ESun, Filamex, FlashForge Dreamer, Hatchbox, Magic Cube, MG Chemicals, NinjaFlex, Taulman, and Zen Toolworks. Some filament spools may require an additional spacer for the spool's hole. For heavier filaments over 0.5 kg, it is recommended to use the newer OmniStand set that can handle loads up to 1 kg or more. FILAMENT SPOOL COMPATIBILITY The quick connect stands are designed to fit a wide range of filament spools with different diameters and sizes. The three filament rod hole positions allow for flexibility in accommodating different sized spools. For example, the bottom rod hole is specifically designed to fit FlashForge Dreamer and Dremel filament spools. Using the 100 mm filament spool rod from the OmniStand set, the stands can accommodate spools with dimensions up to 184x65 mm (7.24x2.55"), 230x65mm, or 190x77 mm. Some rolls may require an additional spacer for the spool's hole. FILAMENT ROD SPACERS For compatible filament rod spacers, please visit the following links: - http://www.thingiverse.com/thing:652415 Instructions for installing the OmniStand quick connect stands are as follows: Step 1: Print the Dreamer-Spool-Stand-Right.stl and Dreamer-Spool-Stand.stl files to create the right and left side stands. Step 2: Insert the stand lock into the print so that it snaps in. Once the lock snaps in, it cannot be removed. Step 3: Switch the lock to the unlock position by sliding the switch up, then slide the stand into the OmniStand stand base (found here: http://www.thingiverse.com/thing:652415). Step 4: Switch the lock to the lock position by sliding the switch down, then slide the stand firmly into place. Step 5: Insert the filament spool rod (found here: http://www.thingiverse.com/thing:652415) into your chosen spool and attach it to the filament stand. PRINT SETTINGS For a proper fit of all parts, print at a layer height of 0.10 mm, use an infill density of 70%, and include three shells. Installation notes: - Print support for overhangs only on the back side of the rod holes. - Do not print with supports the portion where the stand lock is inserted. - Print the stands with their long flat sides facing down to ensure correct printing.