Olympia Drip Tray Cremina Express Coffex Maximatic Livietta

thingiverse

This is my very first Maker project, with special thanks going out to those folks at my university who lent me a hand. It turned out great for me, and I'm hoping this will be just as helpful for others! This replacement drip tray fits an Olympia espresso machine (the Cremina, Coffex, or Maximatic models) or the Pasquini Livietta, which is actually just a rebranded Olympia. I had to trim off a few millimeters from the top "wings" where they meet up with the espresso machine body - that's the back side when you're looking at it from the front. You might need to do the same thing and maybe even sand it down a bit to get it to fit just right, but don't worry, the trimming was super minimal (it took me about 5 minutes to get it done). Check out the photos - the grey drip tray is the one I printed (the black one is the original that I measured so that the proportions would be spot on). The first three photos show how great it turned out from the top, then you can see a comparison of the grey (printed) and black (original) drip trays from the bottom, and finally, from the top again. The fourth photo shows my Pasquini Livietta with the grey (printed) drip tray fitted in perfectly. The fifth and sixth photos show exactly where I needed to cut off a few millimeters of plastic from the end wings so it would fit snugly into the metal frame. And last but not least, the seventh photo shows how the original metal grate fits seamlessly into the grey (printed) drip tray.