OLED Wemos D1 Mini Wedge (run Octoprint monitor or weather display)

prusaprinters

<p>Please post a make if you make this! :)</p><p>Demo of print status screens: <a href="https://imgur.com/a/yX2dhjJ">https://imgur.com/a/yX2dhjJ</a></p><p>Compact Case for Wemos D1 mini wifi ESP8266 with 0.96 Inch Yellow and Blue I2C IIC Serial 128X64 OLED Display.</p><p>Uses (1) 10mm M3 screw for assembly.</p><p><a href="https://www.aliexpress.com/af/22-AWG-3-pin-RGB-cable.html">Used this wire - great for projects!</a></p><p>I used Ziro marble PLA to print this one.</p><p>A few examples of what you can use this for(hardware and software links within):</p><p>(4) wire connections documented in the below software links.</p><p>Octoprint software: <a href="https://www.thingiverse.com/thing:2884823">https://www.thingiverse.com/thing:2884823</a><br/>Weather software: <a href="https://www.thingiverse.com/thing:857858">https://www.thingiverse.com/thing:857858</a></p><p>I wanted as small of a case as I could have with an upright display view to put on my desk.</p><p>You need to bend over the (4) pins so they clear the D1 mini(see pic) or just unsolder the 4 pin connector and remove it and solder the wire directly to the board. I found that bending one pin at a time avoid torquing the connection too much.</p><p>I redesigned the side to include a pass-thru lever to press the reset button when required vs unplugging/replugging the USB power connector.</p><p>To ensure a minimal gap between the body and cap, sand the surfaces of both the body and side panel flat where they contact each other.</p><h3>Print Settings</h3><p><strong>Printer Brand:</strong></p><p>Prusa</p><p> </p><p><strong>Printer: </strong></p><p>I3 MK3S</p><p><strong>Rafts:</strong></p><p> </p><p>No</p><p> </p><p><strong>Supports: </strong></p><p>Doesn't Matter</p><p><strong>Infill:</strong></p><p> </p><p>15%</p><p><strong>Filament:</strong> PolyMaker PLA <br/> </p><p><strong>Notes: </strong></p><p>You can try printing without support for the display opening but I got cleaner results with the bridging with supports.</p><p> </p><p> </p><p> </p><p>Category: 3D Printer Accessories</p>