OLED Nintendo Switch Wall Mount

thingiverse

Remixed to fix a few issues I had with original. *Updated 8-2-23 Realized the wire hole I added did not work out when I went to put mine on the wall, edited it to fit most HDMI plugs as well as moved to the correct location on the back of the dock to easily pass wires down/through. - Added a wire hole - Widened screw hole and head hole to 4mm - 8mm respectively to allow for most drywall screws, including the ones I will be using to mount this. - Added some vent / holes to lessen material usage - Corrected internal measurements to be 175.4 x 50.75mm - Fixed a weird gap / slice down the center of the mount - Added a way to way hide wiring should you need to go left/right once out the wire hole, this bottom mount uses 2x m3x20mm button head screws. There is also an end cap and Arrow on the inside of the tunnel, arrow faces the way you want the wiring to go, end cap goes on the other side. I was going to make it fixed but realized someone may want to put it on the other side instead. May upload a condensed version of this later. Obviously can be printed without the wire channel. I believe that is all I have done to this. I printed using White PLA at 40% infill just because.