-old- Mostly Printed CNC -Add On- Z Adjust Knob

thingiverse

Make adjustments easy to your Mostly Printed CNC by calibrating the Z-Axis simply: Install a 5/16" threaded rod onto two 3/8-16 screws, which are built into this assembly, allowing the use of rods from many 3D Printers with a diameter of 0.312 inches and 5/16 threads per inch on all rods made from this material, such as MakerBot's. Install two 5/16" nuts, with thread, on either end. The first should be secured in place by the nut at one end while keeping it tightened against its counterpart which keeps these components attached to a rigid piece for holding it in line so there will never come times when nothing moves properly - unless this entire device decides otherwise through no fault of your own! Now place an extra length from underneath over where they are already fixed firmly inside before twisting every other way round like how we've said so that each screw points towards one side now after turning just once while making sure everything remains securely held without loosening during operation. At last insert two metal rod parts (both have the end slightly larger than standard M5 which equals a half-inch), put onto these threaded screws located at bottom edge closest together right under first thing attached underneath there already stated within printed description view before tightening with adjustable handle screwed on one end allowing quick fine tuning by turning this single part round as required to set desired range between these upper points when needed during job setup phase ensuring proper engagement without issues happening throughout overall operation process since all has been done according requirements set forth correctly prior moving ahead!