Offset 8mm rod holder for Rigidbot

thingiverse

I struggled to achieve a perfectly level glass bed. I could print diagonally with ease one way, but the other diagonal corners would consistently "sag" and fail to adhere to the bed. After double-checking for any flatness issues with the bed, and inspecting the rods for any signs of bending, I discovered that only one potential issue remained: a slightly bent frame. Instead of attempting to bend the square tubes, I opted to simply offset the rod holders. The effectiveness of this solution will depend on your specific bed level problems. In my case, I needed to utilize two additional mounts and one original holder to achieve the desired results. This is a last resort measure for leveling your bed, best reserved for extreme situations.