office standing desk upgrade

thingiverse

I bought a standing desk with a manual handle to raise and lower. I printed a gear box for a motor to do this automated. There is a baseplate for all the electronics, the motor base for holding the gears and the motor, a controller for the buttons and a limit switch arm. All is PLA except the gears, they're PETG For better alignment two 608ZZ bearings were added. For assambly instructions please visit this project here: https://www.instructables.com/Automate-an-Office-Standing-Desk-With-an-Arduino-a/ Settings: motor base: Res. 0.3mm; Infill 40% gears: Res. 0.15mm; Infill 50% others: Res. 0.3mm; Infill 15% For the motor base supports are recommended.