
Office Conditions Shell
thingiverse
I threw together a temperature and humidity project about a year ago to test the humidity of my home before and after installing a whole house humidifier. The result was terrible, with barely any net change even 90 days after installation. So this quickly became a decoration on my desk to monitor the conditions in my office. Having acquired a 3D printer and wanting to learn AutoDesk Fusion 360, I decided to give this project a little more life, plus help prevent damage when it accidentally falls off my desk because my cat likes to knock it around my office. Pretty basic shell/bumper that has vents next to the temp/humid sensor (in case I do make a lid), a rear hole for a powered USB cable, and support posts that line up with the PCB's drill holes. The support posts provide 1 mm clearance from the base of the shell, and the PCB fits snugly inside. If I had to build this circuit again, I would change the location of some components, as it current layout makes making a lid more time consuming. I've included a few screen grabs from Fusion, an STL file, and the Arduino Code (ino) file. The Arduino Code has a nice pin out table as well as some decent comments (I surprise myself sometimes). Here is a link to the AutoDesk Fusion 360 Files Main Electronic Components: DHT22 Perma-Proto Half-sized Breadboard PCB ATmega328P a .96" SPI Serial OLED from eBay 16MHz Crystal 22pF Capacitor (Quantity: 2) Tactile Reset Switch 10K pull-up resistor for DHT22 1K pull-up resistor for ATmega Print Settings Printer Brand: Robo 3D Printer: R1 ABS + PLA Model Rafts: Doesn't Matter Supports: Doesn't Matter Infill: .25% Density
With this file you will be able to print Office Conditions Shell with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Office Conditions Shell.