Off-set Lift-Off Hinge

cults3d

SO this was sorta of necessity and one of the reasons I love 3D printing. I sorta misjudged the depth of my lack enclosure and my 13 mm Plexiglas surrounds caused the door not to shut. If I pushed the printer back far enough for the door to shut the bed hit the back wall before it met the end stop. I know, I know I should have measured twice and cut once so to say but hindsight being 20/20 I had to adapt. So.... I made these offset hinges to "push the door out the thickness of the Plexiglas. These need to be strong if you print them and have thick ass Plexiglas as I did.\ *** This is only for right swing/side hinges, I did not draw any of these for the left side. The pin orientation is what makes them left and right sided due to the lift off ability. Tight tolerances since I wanted them to be strong.