Odyssey Bumper Fix

cults3d

A few months back, my dad spotted an issue with my Honda Odyssey. The front bumper on my right side was starting to come loose. As it turned out, the end of the bumper had broken off at the spot where it connected to the frame. I probably clipped the bumper on something while backing up, but that piece was completely gone by then. The duct-tape fix looked pretty ugly, so I created a simple design in OpenSCAD for a new piece to attach to the end of the bumper. It took me a couple of attempts to get the measurements just right. The new piece has a large flat surface for a strong glue bond, a hole in the middle to replace the broken screw hole, and a small side piece that matches the existing lines.