Oculus Rift Wall Mount

thingiverse

# Overview This is a basic wall or desk mountable holder for the Oculus Rift CV1. It is designed to be fast to print, and uses a minimum amount of material compared to some of the bulkier designs out there. It fits in place using two screws spaced 100mm apart. It is designed to suit 8G countersunk screws but should also be usable with other sizes. I have used two 8G 30mm screws to fasten it to a desk, as shown in the photos. It features two arms which cradle the headset by means of the hard plastic pivot points on the sides of the headset. The holder does not contact any of the fabric or padding of the headset, which is I think good to protect the headset in the long run. There are also two small hooks which can be used to hang the Oculus Touch controllers (as shown). This design is inspired by similar designs here: https://www.thingiverse.com/thing:2793309 https://www.thingiverse.com/thing:3388960 I was originally going to use one of those, but decided I wanted to make a few changes. Importantly, this design is easier and faster to print, and should be slightly sturdier. # Printing I have printed in PETG with 10% infill. Most materials should be fine to use. Recommended to print so that the part sits flat on the bed, in which case it is only 15mm in the Z axis. This should be the best orientation for the strength of the arms. # Design Designed in SolidWorks. The source file is in the downloads.