Oculus Rift Articulated Sensor Wall Mount

thingiverse

This goes best with my sensor cover https://www.thingiverse.com/thing:3392872 _____ Once again back to the drawing board to combine what I wanted into one product. This mount has a wide range of movement and can technically go full parallel to the surface it's mounted on. **Here's What You'll Need Per Mount:** - For Assembly 2x 4mm Screws and Bolts - For Mounting 1x 4mm Wall Screw (Optionally Double-Faced Adhesive and/or Glue Gun) **What I Ended Up Doing for My Own Mounting:** For my plaster wall, only one wall screw, no visor, no anchor; for my concrete wall, the anchor messed up, so I ended up putting glue around the screw, double adhesive on the back of the mount, put the thing in, then topped it off with the glue gun all around. Bit overkill, but I don't take risks. _____ About the bracket, it was my solution for a very specific problem of mine as you can see in a picture; I've adapted it for regular corners, but to use it properly you'll need a glue gun. _____ **All of My Designs Have Roughly a 0.2 to 0.4 mm Offset/Compensation for Things to Fit** according to how my printer prints. I have no idea if this is a universal problem or not. This mount doesn't have much friction and didn't require any post-processing on my end; the screws needed a tiny push. **Supports on My Designs Are Always Minimal If Not Nonexistent.** Here you should only need them for the base of the hinges, nothing else.