Oculus Quest Anker 13000 battery mount

prusaprinters

<p>Rear battery mount for the Anker PowerCore 13000 battery, and helps take some of the Quests weight off the face.</p> <h3>Print instructions</h3><p>Print bottom side down, break off support tabs around inside zip tie slot and battery indicator.</p> <p>I printed at 0.3mm, 10% infill.</p> <p>Uses 3 pieces of 20mm wide by 1.5mm thick velcro, and an optional ~12" zip tie.</p> <p>It's a tight fit on my battery, and my print settings, so I opted not to use the zip tie in the end.</p> <ul> <li>I've added a no-ziptie version, but YMMV for battery fit, so if in doubt, use the ziptie one instead.</li> </ul>