Oculus Quest 2 (Weed Leaf) Faceplate Cover

thingiverse

Inspired by my wife. This was her idea. Such a good idea. One of my first things. It's an oculus quest 2 faceplate with a pot leaf cutout. Snap it on and enjoy. Personally I recommend a faceplate as it keeps fingers off lenses 90% I added 6 additional clips for better connection. Additional 2 on the top and bottom, and one on each side. If this is too many for you, cut off the desired clips with cutters. Print at high res, 0.2 is the lowest I would go, and 50mm a second is the fastest I would print due to the clips needing precision to fit in, no room for error. I print face down, with supports starting at 40 degrees, 20% support infill. Print, peel off the front from supports and clean it up post print. Enjoy.