Oculus Quest 2 Golf Club Handle Mount

thingiverse

Update: The New file "Quest_Golf_Adapter_JSD_v1.stl" It a brand new version. I started new, so it is not a remix at all. I had an issue with the old one, where some of my friends that play a lot on these broke 2 of them. This one is thicker and also fits the controller a little more snug. Everything is beefed up a little more. I am hoping this one will be much harder to break. Only time will tell I guess. "Quest_Golf_Adapter_JSD_v2.stl" Is the same as above, you can see I change it up some. Either one works fine, not sure one is really better than the other. V2 has more plastic so may be a bit stronger, but weigh more. Used M3x40mm bolts because needs to be slightly longer than the V1 version that uses the M3x30mm The version 2 file. "Golf_Adapter_14.7_2_Straps_Edited_v2.stl" Is a remix, changed a lot. I used a M3x30mm hex screw and nut to bolt thru the golf handle as well as some epoxy in to the printed part. I cut 30mm from the rubber handle on the club and attached in to the printed part, that should leave 3-4mm between rubber handle and the printed part. Drilling holes in each side of the gold club tube for the bolt was not easy. I had a hard time, tried different things, was even thinking of buying a small drill press. But ended up using a Dremel with a cutting blade to just cut a small slit where I wanted the holes, then used a drill to make the holes bigger and that worked out very well, and really easy. Testing went really good, I used these straps and they worked, I may try the 12" straps next and see how they do. (1" x 18" )12 pack https://www.amazon.com/gp/product/B07CVFTRYJ