Oculus Quest 2 DIY Elite Strap Print Flat Remix

thingiverse

I have remixed Wimi1s Oculus Quest 2 DIY (Elite) Strap V1.0 so that you can print it flat. It reduced the print time for me from about 4h to not much over 1h while using a lot less material for supports - with the aditional benefit of beeing less prone to break due to the different layer layout in use. You have to print this in material that you can still form after printing. I've printed this in PLA, put it in a hot (not boiling) water bath and bend it SLOWLY (with some gloves on so I dont burn myself). You could probably also use a hairdryer. I am planning to add some foam to it for an even more comfortable fit.