OctoPrint Raspberry Pi Model 3A+ Case for Ender-3 v2

thingiverse

Took the Raspberry Pi 3 A+ Case from CoreElectronics and modified it to fit the ender3 v2 support bracket base from kingstonrichard. Also modified the case to include the standoff design from kingstonrichard's case. - Case was a really tight fit around pi when I printed it, but it did work - Case was extremely tight fit around bracket, may want to rework a bit but measurements should be same as original - When using a 3A for octoprint it's enough power. Only thing is if keeps power to the screen when pi is on. On some pis you can change the usb power digitally... but for this one just put a little black tape over the +5v pin on the USB cable to keep it disconnected, it's not required for the pi => ender communication and stops the screen from powering on.