Octoprint Monitor PROWL / LED add-on (job finished notification))

thingiverse

01/21/2019: updated to Version 5. 01/03/2020: changed version from V3 to V4. Now the red LED will turn off after Octoprint is disconnected at 100% print completion. 01/02/2020: now available in both German and English translations! This is a firmware add-on for the original Octoprint Monitor: https://www.thingiverse.com/thing:2884823. First, follow the instructions of the original monitor until it works. Use the sketch; do not use the binary file. There may be an issue with the ArduinoJson library in the original file. You must use a 5.x version, not any 6.x. If everything is working correctly, proceed with the PROWL / LED modification. This add-on integrates the PROWL (https://www.prowlapp.com/) push notification service. This service sends a push message to an iOS device like iPhone/iPad even if they are on or in standby mode. The message informs the user instantly when the 3D print job is complete at 100%. A LED on top of the monitor housing flashes in this case. I do not provide modified files from the original but describe how to add necessary code lines in the Arduino sketch. ------------------------------------------------------------------------------------------------------------------- This is a firmware extension for the original Octoprint Monitor: https://www.thingiverse.com/thing:2884823. This integrates the PROWL (https://www.prowlapp.com/) push notification service. This service sends a message to an iOS device like iPhone/iPad, even if they are in standby mode. The message immediately informs the user when the 3D print job is complete. A LED on the housing flashes then. I provide no finished files; only a description of which code lines must be inserted into the original Arduino sketch where. I recommend first bringing the original sketch online.