OctoPrint case with 3.5 TFT for M2

thingiverse

I tweaked the original design a bit, it was too constricted. It might even be a tad oversized for some configurations but the board will definitely fit inside. The current USB cable positioning isn't ideal as it hangs over the filament spool. A flat design could solve this issue by allowing the cable to drop straight down instead. Let me know if you'd like me to implement this. I prefer this setup as it enables me to check the screen while standing upright. To accommodate a webcam, I will add a triangular arm that slides into the space under the board. Print Settings Rafts: Yes Supports: Yes Resolution: 0.2mm Infill: 15% Notes: Printed in PLA Post-Printing 2 * M3 (or M4) screws, nuts and washers are required.