OctoPi 5" Touch Screen Enclosure REMIX VERSION1 fanless

thingiverse

ATTENTION! V2 AVAILABLE WITH A FAN AND MORE IMPROVEMENTS. I WILL WORK ON V2 EXCLUSIVELY FROM NOW ON. V1 IS EOL :) Changelog since upload: - OP's recommended screen was 2mm thicker than expected. Removed 2mm off of the front plate to account for that _____________________________________________________________ For OP's instructions on how to set up the pi and how it looked IRL, please refer to the original thing: https://www.thingiverse.com/thing:3318115 I simplified this model for easier, sturdier assembly. It now uses 4mm melting M3 Thread inserts for mounting the frontplate and mounting the case to any given surface in the back. Also added a hole for a output socket (for PSU control. more on that later) misc fixes: -removed a bit of the buttom palte, due to the USB Ports of the Raspberry Pi 3b interfering with it. now the screen should lay flush on the stands. -no more clips, but exclusively 4mm melt thread inserts (M3) -did some cleanups here and there and removed the tunnels for the clips, since they're obsolete here. -removed the gigantic mounting plate, due to it being obsolete here (it was basis of the clip mechanism)