Octopi 3B+ Case for K8200

thingiverse

I needed a casing for Raspberry Pi 3B+ which runs Octopi to control my K8200. This one slips into the right-hand aluminum bar directly, so requires no other attachment. Printed at 0.2mm layer height using Cura. It does need support for the parts that slip into the aluminum bar; I used the Gyroid option which worked well. I also used a 6mm brim for adhesion. I printed this at 20% infill as my first prototype and it works fine, but will probably reprint at 100% to get a better finish. Note: Doesn't need screws as the lid fits quite tightly.