Ocie's Duet Wifi Enclosure Box remix for the Full Bear MK2/2.5

thingiverse

UPDATE 5/21/2019: The Duet WiFi enclosure will no longer be updated since only the MK3 version can be purchased in the future, which will be compatible with MK2/2.5. Find the correct Duet WiFi enclosure at https://www.thingiverse.com/thing:3642653. UPDATE 5/19/2019: I realized that there is a difference between the MK3 and MK2/2.5 Full Bear frames' rear Y axis extrusion and Z axis measurements. This design is specifically for the MK2/2.5 Full Bear frame, and an MK3 version is in the works. Hey Everyone! I recently purchased a Duet 2 WiFi and planned to build another Full Bear, but needed an enclosure that would fit the Duet 2 WiFi on the frame. After searching online, I found Ocie's box via someone on Facebook's Prusa i3 Bear Upgrade group. However, I wanted the box to better fit the frame without being too tall. Pekcitron suggested venting forced air away from the print area for tall prints and dissipating heat on the external side so it doesn't pick up heat from the heatbed. I tried adding a redirection for the forced air at the top and shortened the tabs that attach to the Z axis frame to fit properly. The hole in the bottom that sits on the back Y axis extrusion has been centered on the vslot, allowing you to use it to secure the enclosure to the frame. I also made the lid more shallow per request as it was very close to the X axis motor. The fan shroud in the lid has been re-adjusted to accommodate only the Noctua 40x10mm fan. I still need to make a couple of modifications, including adding a bear logo on the lid and putting a vslot profile on the tabs so that it seats better and there's less chance to pull the screw through when tightening. I printed this in PETG without supports, which was probably a bad idea. My hole at the bottom sucks, and so do the colors where the wires go in. The "extension" slides snugly into the pocket behind the Z axis extrusion; it's just to give you some more room (I wanted to put two Wago 221-413 connectors in there but haven't gotten to that point yet). Feel free to download this and modify the parts with the included Fusion 360 files. This was just a start for a way to have a Duet 2 on my Bear frame. Thank you to Ocieward for the Duet 2 original enclosure and thank you to Pekcitron for the Bear upgrades! And remember, this is a work in progress. Oh, and for the love of me I still can't get the back to orient properly for you to just drag and drop into Slic3r, so make sure the back is to the bed when you print. Use Ocie's print settings.